Part 3

	Ahhh… Lightsheet. Amazing stuff. Pretty easy to work with although when you trim it the edges have a tendency to short out. When this happens localize the short by trial and error (disconnecting one then the other sheets) and then trim the edges again, slightly. Hopefully you’ll remove the short. Lightsheet man gives instructions for remedying this otherwise, but it didn’t work for me…
	The lightsheet in its place below the consoles. Originally I was going to put grain-o-wheat bulbs under the console, but the stock PL console doesn’t allow much room for this. Lightsheet is ideal.
	Another view of the control consoles.
	Test fitting the upper bulkheads. Again. Good view of the flashy light circuit powering LED’s behind the Comms console.
	Detail of building the control panel starboard of the entry way on the upper deck.
	It was sometime around here that I decided to leave the deck clear.
	And clear it became.

Next