|
April, 2004
|
|
Here's the
windshield installed and the dash taken out to be covered.
The windshield holes needed to be opened up, so I recommend a
test fit before doing your paint. |
| Covering
the dash.
To get a good tight fit, I
laid the material on a some plywood and nailed it to one
end. Then stretched it about 3 inches to pull the wrinkles
out and nailed it to the plank. I then sprayed the
adhesive on the material and the dash and placed the dash on the
material. I put some bricks on the dash and let it sit
overnight before finishing the job.
|
|
|
|
Here's the
finished dash installed |
| This
is my co-pilots first ride. What a blast...with one minor
exception. If you look in the picture above, you'll notice
the hood handles aren't installed. I forgot to take the
hood off, and on our drive, the hood went flying over our
heads...a good 20 feet in the air. The Co-Pilot wouldn't
stop laughing...thankfully, there was nobody behind us.
DON'T FORGET TO INSTALL THE
HOOD HARDWARE
|
|
Check back for updates
|
